User Manual

Connecting ComLink to PC Download pump
1. Make sure that a bolus is not in progress on the pump. If a
bolus is being delivered, allow bolus to finish before download-
ing pump.
Any bolus delivery in progress on the pump will be
cancelled during the download process.
2. Extend the cable (provided) the full length away from the PC to
minimize possible communication interference from the PC.
3. Position the pump within six (6) feet of the ComLink to down-
load.
4. Enter the first six (6) digits of the pump serial number into the
PC software program. The number is located on the rear of
your pump.
5. In the PC software, set the communications port setting to the
serial port that the cable is attached to (example: COM1,
COM2).
6. Refer to the User Guide provided with your Medtronic MiniMed
PC software program for detailed information on downloading
your pump.
CAUTIONS: The pump will be in “SUSPEND” dur-
ing downloading. Make sure the pump
is taken out of “SUSPEND” when
downloading is complete.
Do not use the pump remote control
when the pump is in communication
with the ComLink.
NOTE: If the pump battery is low the pump will not
send data to the ComLink. Check the STATUS screen
in the pump to verify that the battery is not low.
Replace battery if low.
1
2
3 4