User Manual
Table Of Contents
- Table of contents
- Glossary
- Before you begin...
- The basics...
- Basic programming
- Starting on insulin
- Using Bolus Wizard
- Optimizing pump therapy
- Insulin pump therapy follow-up
- Utilities
- Troubleshooting and alarms
- Troubleshooting
- My pump has a no delivery alarm...
- What happens if I leave the battery out too long?
- Why doesn’t my pump battery last very long?
- What is a CHECK SETTINGS alarm?
- My screen appears distorted...
- I can’t get out of the priming loop...
- The pump is asking me to rewind...
- My bolus stopped...
- My pump buttons are not acting right during a bolus...
- My pump won’t display my BG reading from my meter...
- I dropped my pump
- I submerged my pump in water
- Alarms
- Alarm conditions
- Troubleshooting
- Pump maintenance
- User safety
- Pump specifications
- Alarms and error messages
- Alarm history
- Backlight
- Basal
- BG target
- Bolus delivery
- Bolus history
- Bolus units
- Bolus Wizard
- Carb ratios
- Carb units
- Daily totals
- Default screen
- Delivery accuracy
- Drive motor
- Dual Wave bolus
- Easy bolus
- Infusion pressure
- (insulin) sensitivity
- Insulin type
- Low resv (reservoir) warning
- Meter value
- Normal bolus
- Occlusion detection
- Percent temp basal
- Power supply
- Prime function
- Prime history
- Program safety checks
- Pump size
- Pump weight
- Remote control
- Reservoir
- Square Wave bolus
- Status screen
- Temporary (temp) basal rate
- Time and date screen
- Water tight
- Bolus Wizard specifications
- Default settings
- Icon table
- Menu map
Basic programming 33
Resume pump delivery
When the pump is suspended, it defaults to the HOME screen with solid circles.
Do these steps to resume your pump and basal delivery:
1. From any screen, press ACT until the RESUME screen appears.
Press ACT again.
2. Your pump will beep once, then the HOME screen will appear (with no circles).
NOTE - A bolus or fixed prime that was stopped by suspend will not
restart when you resume your pump. You must reprogram and activate
it to finish delivery.
Practice:
Resume basal delivery after a suspend
Make sure you are NOT connected to your pump while practicing.
Give a 3.0 unit bolus now. While it is delivering, suspend the bolus.
Check here if you were able to suspend the bolus.
Now restart the pump.
Check here if you were able to restart the pump.
RESUME
ACT-Restart Basal
Stopped at 1:05P
ACT
ACT
MiniMed
MiniMed
MiniMed