User Manual
Table Of Contents
- Table of contents
- Glossary
- Before you begin...
- The basics...
- Basic programming
- Starting on insulin
- Using Bolus Wizard
- Optimizing pump therapy
- Insulin pump therapy follow-up
- Utilities
- Troubleshooting and alarms
- Troubleshooting
- My pump has a no delivery alarm...
- What happens if I leave the battery out too long?
- Why doesn’t my pump battery last very long?
- What is a CHECK SETTINGS alarm?
- My screen appears distorted...
- I can’t get out of the priming loop...
- The pump is asking me to rewind...
- My bolus stopped...
- My pump buttons are not acting right during a bolus...
- My pump won’t display my BG reading from my meter...
- I dropped my pump
- I submerged my pump in water
- Alarms
- Alarm conditions
- Troubleshooting
- Pump maintenance
- User safety
- Pump specifications
- Alarms and error messages
- Alarm history
- Backlight
- Basal
- BG target
- Bolus delivery
- Bolus history
- Bolus units
- Bolus Wizard
- Carb ratios
- Carb units
- Daily totals
- Default screen
- Delivery accuracy
- Drive motor
- Dual Wave bolus
- Easy bolus
- Infusion pressure
- (insulin) sensitivity
- Insulin type
- Low resv (reservoir) warning
- Meter value
- Normal bolus
- Occlusion detection
- Percent temp basal
- Power supply
- Prime function
- Prime history
- Program safety checks
- Pump size
- Pump weight
- Remote control
- Reservoir
- Square Wave bolus
- Status screen
- Temporary (temp) basal rate
- Time and date screen
- Water tight
- Bolus Wizard specifications
- Default settings
- Icon table
- Menu map
Basic programming 31
Stopping your pump
You can stop your pump with the suspend function. Suspend stops all insulin delivery including the current basal and
any bolus or prime deliveries that are in progress. While suspended, your pump will not deliver insulin until you
Resume your pump. When basal is resumed, the pump is taken out of the Suspend mode.
The pump will beep or vibrate about every 15 minutes on the hour to remind you that it is not delivering insulin.
Example: You suspend your pump at 11:20AM. The pump will beep/vibrate at 11:30AM, 11:45AM, 12:00PM, and so on
until you resume your pump (basal resumes).
NOTE - When suspended, your pump is in Attention mode (solid circles). When in Suspend, you can
only resume your basal or view the STATUS screen. No other functions are available.
Do these steps to suspend your pump:
NOTE - Press
ESC
to view the STATUS screen
and verify your pump is suspended.
1. Select Suspend from
the MAIN MENU, and
press ACT.
2. SUSPEND will flash.
Press ACT to stop
your pump.
3. The screen will show that the pump
is suspended and the time that it
stopped. After a few minutes, the
pump will default to the HOME
screen with solid circles.
ACT
MAIN MENU
Bolus
MiniMed
Basal
Suspend
ACT
MiniMed
SUSPEND
Press ACT to Stop Pump
(flashing)
MiniMed
SUSPEND
Stopped at 1:05P
MiniMed
MiniMed
STATUS 1:10P U100fast
Suspended at 01:05P
Last Bolus N 3.8U
7:58A 22 AUG