User Manual

100 Chapter 8
Select your insulin type
The factory setting for the insulin type is 100U fast-acting. If you are preparing your pump for the first time, or
you have changed insulin type and need to change the pump setting, do these steps:
NOTE - When you change the insulin type in your pump, you will also have to rewind your pump.
1. Go to the INSULIN TYPE screen and select your type.
Press
ACT.
Main > Prime > Insulin Change
2. The pump will siren (or vibrate) and the INSULIN CHANGE.
screen will appear to warn that you are changing your
insulin type. Press
ACT to continue.
TIP - If you realize you do not want to change insulin type,
press
ESC
now. The PRIME Menu will appear. Exit the
menus. No changes will be made.
3. Read the message on the screen and press ACT again to
continue. To cancel, press
ESC.
4. The VERIFY INSULIN CHANGE screen will appear. Select
Yes
if the insulin type is correct. Press
ACT and continue to step 5.
If the insulin type is not correct:
a. Select No and press ACT. The INSULIN TYPE screen will
appear again (see step 1).
b. Repeat steps 1 through 4.
5. The REWIND screen will appear for 30 seconds, then default to the
HOME screen. You must now rewind your pump as described in the section,
“Rewinding your pump” in chapter 4.
WARNING: Do not change your insulin type unless your healthcare professional has instructed you
to do so.
Make sure you select the correct insulin type. The correct insulin type is essential for
proper use of the Bolus Wizard.
MiniMed
INSULIN TYPE
U100 Regular
U100 Fast Acting
ACT
MiniMed
INSULIN
ACT
CHANGE!
MiniMed
PRIME MENU
ESC
Rewind
Prime History
Insulin Change
to
cancel
to continue
MiniMed
Consult your
changing insulin
therapy.
ESC
to cancel
physician before
ACT
VERIFY INSULIN CHANGE
Yes
U100
No
Fast Acting
ACT
to continue
MiniMed
REWIND
Disconnect from Body
Press ACT to Rewind
MiniMed
mp6024875_012_a.book Page 100 Monday, June 23, 2003 10:54 AM