User Manual

Starting on insulin 37
Rewinding your pump
Before you continue, make sure the pump is NOT connected to your body.
1. If you removed your reservoir and are replacing it, go to the REWIND screen.
Main > Prime > Rewind
NOTE - If you just changed your insulin type and the HOME screen
appears, you can press
ACT to make the REWIND screen appear.
2. In the REWIND screen, press ACT to start the rewind process.
The REWINDING screen will appear while the pump rewinds.
3. After the pump rewinds, the MANUAL PRIME screen will
appear.
If you are practicing, do these steps:
a. Do NOT insert the reservoir in your pump.
Make sure the shipping cap is installed in the reservoir compartment.
b. Continue with the manual prime instructions described in the “Manual prime” section on the next page.
If you are not practicing, continue to the next section, “Inserting the reservoir in your pump.”
WARNING: Make sure the infusion set is disconnected from your body before you rewind or prime the
pump. Never insert the reservoir into the pump while the tubing is connected to your
body. Doing so could result in an accidental infusion of insulin.
REWIND
Disconnect from body
Press ACT to Rewind
MiniMed
ACT
REWIND
Disconnect from body
Press ACT to Rewind
MiniMed MiniMed
REWINDING
Wait for notification
REWIND
Disconnect from body
Press ACT to Rewind
ACT
MiniMed
MiniMed
MANUAL PRIME
Disconnect from Body
Insert/Lock Reservoir
Hold ACT to Prime
MiniMed
mp6024875_012_a.book Page 37 Monday, June 23, 2003 10:54 AM