User Manual

55
1. Place the remote face down on a secure, flat surface.
2. Unsnap the rear panel by twisting a coin or screwdriver between
the plastic key ring loops. Remove
the used battery and discard
properly.
3. Insert a new A23 battery accord-
ing to the diagram on the remote
transmitter case. When inserting
the new battery, do not touch any
of the exposed electronics.
4. Replace the rear panel and snap
the panels together to assemble
the remote transmitter.
Your remote transmitter should be
able to transmit to the pump as soon
as the battery is inserted.
If this does not happen:
a. Check to see if the battery is inserted properly.
b. If the battery is inserted properly and the remote transmitter
green LED light does not flash, install a new battery.
Remote transmitter Care
and Maintenance
installing a new battery
44
1. Press and hold
AACCTT
on the remote transmitter for at least three
seconds to ‘wake up’ the pump. When the pump is awake, it will
beep or vibrate.
2. To suspend pump delivery,
press the
SS
button, then press
AACCTT
. Three audible
beeps/vibrations will confirm
that the pump is in suspend
mode.
3. To resume basal delivery, press
and hold
AACCTT
on the remote
transmitter for three seconds.
This will “wake-up” the pump.
Next, press the
SS
button, then
press
AACCTT
. The pump will beep/vibrate once and then will resume
basal delivery.
ACT
S
B
Using the Remote Transmitter
to Suspend/Restart the Pump
Your pump “looks” for a signal from the remote transmitter
every two to three seconds. This is why you need to press
and hold the
AACCTT
button on the remote transmitter before
you can program.
Continuing to hold the
AACCTT
button after the pump wakes
up may result in the pump returning to sleep mode.
If the wrong button is pressed, simply wait 30 seconds for
the command to time out.
Need to Know