User Manual

33
Using the Remote Transmitter
to Deliver a Bolus
1. Turn ON Easy Bolus.
2. Press and hold
AACCTT
on the remote transmitter for at least three
seconds to ‘wake up’ the pump. When the pump is awake, it will
beep or vibrate. You will now be able to program an easy bolus.
3. Press the
BB
button as many times as you want to select the bolus
amount. Each press will
result in a beep or a vibra-
tion. The beeps will change
in pitch to assist your
counting.
Review Easy Bolus in man-
ual for more info on this
feature
4. Press
AACCTT
. The pump will beep or vibrate back the amount you
just selected. Count the beeps/vibrations. If this amount is correct,
press
AACCTT
to deliver.
If the amount is incorrect, let the pump “time out”. (Do not
press any buttons for 30 seconds.) To restart programming, you
will need to wake up the pump again.
ACT
S
B
WHY
: Allows you to deliver an Easy Bolus using the remote
transmitter
H
OW:
22
The remote transmitter is designed to operate within
approximately 2 feet of your pump.
Need to Know
When the remote transmitter is in “sleep mode”, the
green LED light will be off.
After you have awakened your pump by pressing and
holding the
AACCTT
button, the green LED light will glow
and flash rapidly.
When the battery is low, the LED will blink in a series of
three quick flashes until the battery is replaced. When
this happens, replace the battery in the remote transmit-
ter as soon as possible.
If the LED blinks in a series of more than three quick
flashes, call MiniMed.
Need to Know