User's Manual

ManualsBrandsMedtronic MiniMed ManualsElectronicsPersonal Pump Communicator

Table Of Contents

Table of contents
List of figures
CHAPTER 1 Description
- Introduction
- Implantable Insulin Pump
CHAPTER 2 Indications and contraindications
- Indications for use
- Contraindications for use
- Possible adverse effects
CHAPTER 3 Personal Pump Communicator (PPC)
- Introduction
- Part 1: PPC/Pump system initialization
- Part 2: Additional PPC programming features
- Main menu
- Programming a basal rate
- Personal events
  - History
- Setup Pump
- Setup II
- Audio Bolus
- Supervisor mode
CHAPTER 4 Pump implantation
- Preprogramming and pre-testing the Pump
CHAPTER 5 Pump refill procedure
- Introduction
  - Supplies and solutions
    - Supplies:
    - Solutions:
  - Prepare for pump refill
- Perform the refill procedure
CHAPTER 6 Explanting the Pump System
- Explant considerations
- Returning devices/components to Medtronic MiniMed
CHAPTER 7 Warnings and precautions
- Warnings
- Precautions
CHAPTER 8 Adverse reactions
- Adverse reactions
- Prevention
CHAPTER 9 System alarms and messages
- Pump alarms
CHAPTER 10 Troubleshooting Pump System under-delivery
- Diagnostic procedures
- Under-delivery caused by backflow
- Under-delivery caused by catheter occlusion
CHAPTER 11 Technical specifications
- Implantable Insulin Pump MMT-2007D
- Personal Pump Communicator (PPC) model MMT-3160
- Side Port Catheter
- FCC compliance
APPENDIX A Label information symbol dictionary
- Packaging
- Other information
APPENDIX B Implant worksheet
- Implant worksheet form
APPENDIX C Refill form
- Pump refill data
APPENDIX D Precautions and general procedures
- Special note and precautions
APPENDIX E Pump rinse procedure
- Supplies and solutions
- Preparing for the procedure
- Remove insulin from the Pump and fill with NaOH
- Equilibrate and pull NaOH through system
APPENDIX F Side Port Catheter flush procedure
- Supplies and solutions
- Preparing for the procedure
- Flushing the Side Port Catheter
APPENDIX G Stroke volume measurement
- Supplies and solutions
- Preparing for the procedure

Pump implantation

10. At the end of the bolus, rinse the outside of the Pump thoroughly with sterile

water to remove traces of INSULIN. The Catheter tip should not be placed in

the water. Protect the Pump with sterile drapes until the surgeon is ready to

implant it. Verify that the priming bolus is finished or canceled prior to the

implantation.

The Pump and Catheter are now ready for implantation.