User's Manual

Personal Pump Communicator (PPC)
43
Supervisor mode
To access Supervisor Mode (by a health care professional only) press SEL 6
times in the "SETUP PUMP" screen, then press and hold the  and  buttons
simultaneously. Hold them down until the screen changes the "ENTER SUPER-
VISOR PASSWORD" screen.
Refill
The refill procedure will be described in Chapter 5 “Pump Refill Procedure.” The
following screens are used at the end of this procedure, and allow you to enter the
new refill volume and to calculate the refill accuracy.
1. The "PUMP REFILL" screen appears when you
access the Supervisor Mode. Press ACT.
2. The PPC prompts for the residual amount of
insulin removed from the Pump. Use the  and
 buttons to enter the weight (grams) of
extracted insulin.
3. Press ACT and the PPC prompts for the refill
insulin amount. Use the  and  buttons to
enter the weight (grams) of insulin refilled in the
Pump.
4. Press ACT. Confirm that the insulin
concentration defaults to U-400. Press ACT
again.
5. Place the PPC near the Pump to complete the
process.
PUMP REFILL
SET
EXTRACTED AMOUNT
---- ---- g
SET
REFILL AMOUNT
---- ---- g
SET
INSULIN U400
CONCENTRATION
PPC
COMMUNICATING