User's Manual
Table Of Contents
- Table of contents
- List of figures
- CHAPTER 1 Description
- CHAPTER 2 Indications and contraindications
- CHAPTER 3 Personal Pump Communicator (PPC)
- CHAPTER 4 Pump implantation
- Preprogramming and pre-testing the Pump
- CHAPTER 5 Pump refill procedure
- CHAPTER 6 Explanting the Pump System
- CHAPTER 7 Warnings and precautions
- CHAPTER 8 Adverse reactions
- CHAPTER 9 System alarms and messages
- Pump alarms
- Alarm feedback
- Pump low battery
- Depleted pump battery
- System error
- Pump self test fail
- PPC low battery
- PPC alarms
- Low reservoir
- Empty reservoir
- Telemetry communication error
- Initialize alarm
- PPC not initialized
- Battery replacement
- Initialize to factory defaults
- Pump stopped
- Pump suspended
- Auto off
- Hourly maximum exceeded
- Pump alarm table
- Pump alarms
- CHAPTER 10 Troubleshooting Pump System under-delivery
- CHAPTER 11 Technical specifications
- APPENDIX A Label information symbol dictionary
- APPENDIX B Implant worksheet
- APPENDIX C Refill form
- APPENDIX D Precautions and general procedures
- APPENDIX E Pump rinse procedure
- APPENDIX F Side Port Catheter flush procedure
- Supplies and solutions
- Preparing for the procedure
- Flushing the Side Port Catheter
- Program minimal basal rate
- Remove insulin and fill with rinse buffer
- Equilibrate and pull rinse buffer through system
- Flush side port catheter
- Remove rinse buffer and fill with insulin
- Equilibrate and pull insulin through system
- Remove guide needles and record refill amount
- Program new basal rate
- Remove rinse buffer from catheter
- APPENDIX G Stroke volume measurement
Personal Pump Communicator (PPC)
39
Basal delivery pattern
This feature is previously described in this Chapter.
Initialize PPC to Pump
From the “SETUP PUMP” screen press ACT until “INITIALIZE PPC TO
PUMP” is displayed. This option “marries” the PPC to the Pump, and it is used to
initialize a new PPC. For initialization programming follow the steps described
in, Part 1: PPC/Pump System initialization of this Chapter.
Setup II
“SETUP II” permits access to an additional group of Setup menus for the Pump.
From the “SETUP PUMP” screen, press ACT until the “SETUP II” screen is dis-
played. "SETUP II" features are presented in the next section.
Exit Setup menu
1. From the "SETUP PUMP” screen, press SEL
until the “EXIT SETUP MENU” screen is
displayed. Press ACT. The PPC will return to the
Time/Date screen.
EXIT SETUP MENU