User's Manual

Personal Pump Communicator (PPC)
16
3. When a communication link has been established,
the screen will read, “PPC COMMUNICATING”,
and then will change to the next screen.
4. “NO” is blinking. Check to make sure the serial
number displayed on the screen matches the
Pump serial number. Press either  or  once to
change “NO” to “YES” and then press ACT.
Place the PPC over the Pump.
5. The screen again reads “PPC
COMMUNICATING”, and the PPC will beep 3
times at the end of the programming sequence.
During this process, the PPC receives all of the
factory preset values contained in the Pump
memory.
6. The screen will read “PUMP SUSPENDED”. The
Pump and PPC are now “married”.
7. Press SEL, then ACT and place the PPC near the
Pump.
8. The screen now reads “PUMP INITIALIZED”.
9. Press SEL and then ACT again, and the PPC will
display the Time/Date screen.
NOTE: When the alarm type is set to
“VIBRATE” the beeps from the
PPC during normal programming
will be low volume.
PPC
COMMUNICATING
INITIALIZING "NO"
PPC to PUMP
• • • • • • • • • • • • • • • •
• • • • • • • • • • • 47568
COMMUNICATING
PPC
PUMP SUSPENDED
PPC
COMMUNICATING
PUMP INITIALIZED
11:16 JAN O2