User's Manual

ManualsBrandsMedtronic MiniMed ManualsElectronicsPersonal Pump Communicator

Table Of Contents

Table of contents
List of figures
CHAPTER 1 Description
- Introduction
- Implantable Insulin Pump
CHAPTER 2 Indications and contraindications
- Indications for use
- Contraindications for use
- Possible adverse effects
CHAPTER 3 Personal Pump Communicator (PPC)
- Introduction
- Part 1: PPC/Pump system initialization
- Part 2: Additional PPC programming features
- Main menu
- Programming a basal rate
- Personal events
  - History
- Setup Pump
- Setup II
- Audio Bolus
- Supervisor mode
CHAPTER 4 Pump implantation
- Preprogramming and pre-testing the Pump
CHAPTER 5 Pump refill procedure
- Introduction
  - Supplies and solutions
    - Supplies:
    - Solutions:
  - Prepare for pump refill
- Perform the refill procedure
CHAPTER 6 Explanting the Pump System
- Explant considerations
- Returning devices/components to Medtronic MiniMed
CHAPTER 7 Warnings and precautions
- Warnings
- Precautions
CHAPTER 8 Adverse reactions
- Adverse reactions
- Prevention
CHAPTER 9 System alarms and messages
- Pump alarms
CHAPTER 10 Troubleshooting Pump System under-delivery
- Diagnostic procedures
- Under-delivery caused by backflow
- Under-delivery caused by catheter occlusion
CHAPTER 11 Technical specifications
- Implantable Insulin Pump MMT-2007D
- Personal Pump Communicator (PPC) model MMT-3160
- Side Port Catheter
- FCC compliance
APPENDIX A Label information symbol dictionary
- Packaging
- Other information
APPENDIX B Implant worksheet
- Implant worksheet form
APPENDIX C Refill form
- Pump refill data
APPENDIX D Precautions and general procedures
- Special note and precautions
APPENDIX E Pump rinse procedure
- Supplies and solutions
- Preparing for the procedure
- Remove insulin from the Pump and fill with NaOH
- Equilibrate and pull NaOH through system
APPENDIX F Side Port Catheter flush procedure
- Supplies and solutions
- Preparing for the procedure
- Flushing the Side Port Catheter
APPENDIX G Stroke volume measurement
- Supplies and solutions
- Preparing for the procedure

Personal Pump Communicator (PPC)

2. Press SEL then ACT, and place the PPC near the

Pump.

3. Wait a few seconds for the communication to

complete.

NOTE: When the PPC displays “PPC

LOW BATTERY”, the message can be cleared, and

programming continued. There should be sufficient

energy in the battery to communicate with the Pump a few

more times, but the battery should be changed as soon as

possible.

NOTE: If while programming the PPC, the screen goes blank, the

PPC beeps six times and then the “CHECK PUMP

STATUS” message appears, the battery needs to be

replaced.

PPC

COMMUNICATING