User's Manual
Table Of Contents
- Table of contents
- List of figures
- CHAPTER 1 Description
- CHAPTER 2 Indications and contraindications
- CHAPTER 3 Personal Pump Communicator (PPC)
- CHAPTER 4 Pump implantation
- Preprogramming and pre-testing the Pump
- CHAPTER 5 Pump refill procedure
- CHAPTER 6 Explanting the Pump System
- CHAPTER 7 Warnings and precautions
- CHAPTER 8 Adverse reactions
- CHAPTER 9 System alarms and messages
- Pump alarms
- Alarm feedback
- Pump low battery
- Depleted pump battery
- System error
- Pump self test fail
- PPC low battery
- PPC alarms
- Low reservoir
- Empty reservoir
- Telemetry communication error
- Initialize alarm
- PPC not initialized
- Battery replacement
- Initialize to factory defaults
- Pump stopped
- Pump suspended
- Auto off
- Hourly maximum exceeded
- Pump alarm table
- Pump alarms
- CHAPTER 10 Troubleshooting Pump System under-delivery
- CHAPTER 11 Technical specifications
- APPENDIX A Label information symbol dictionary
- APPENDIX B Implant worksheet
- APPENDIX C Refill form
- APPENDIX D Precautions and general procedures
- APPENDIX E Pump rinse procedure
- APPENDIX F Side Port Catheter flush procedure
- Supplies and solutions
- Preparing for the procedure
- Flushing the Side Port Catheter
- Program minimal basal rate
- Remove insulin and fill with rinse buffer
- Equilibrate and pull rinse buffer through system
- Flush side port catheter
- Remove rinse buffer and fill with insulin
- Equilibrate and pull insulin through system
- Remove guide needles and record refill amount
- Program new basal rate
- Remove rinse buffer from catheter
- APPENDIX G Stroke volume measurement
System alarms and messages
93
Initialize alarm
Attempting to initialize a PPC to a Pump that is not compatible with it, results in
one of the following messages. The physician should press SEL and ACT to
clear the alarm, then verify the personal ID of the Pump is correct.
Attempting to initialize a PPC to a Pump that contains invalid stroke volume or
insulin concentration information, results in one of the following messages to be
displayed. Contact Medtronic MiniMed for instructions.
Responding “NO” to the “INITIALIZE PPC TO PUMP" 8 consecutive times will
result in the following message being displayed. Step away from any other Pump
in the area and perform the request again.
PPC not initialized
If the PPC is not initialized to a Pump, the following message is displayed:
When successfully completing a PPC initialization, the following message is dis-
played:
PPC Display Type of Alarm
PUMP ERROR
0 or 1
1
PPC Display Type of Alarm
PUMP ERROR
40 or 41
1
PPC Display Type of Alarm
TELEMETRY
ERROR
20
1
PPC Display Type of Alarm
PPC
NOT INITIALIZED
1
PPC Display Type of Alarm
PUMP INITIALIZED 1