Technical Specs Part 3
Table Of Contents
- CHAPTER 9 System Alarms and Messages
- Pump alarms
- Alarm feedback
- Pump low battery
- Depleted pump battery
- System error
- Pump self test fail
- PPC alarms
- PPC low battery
- PPC depleted battery
- PPC needs servicing
- Low reservoir
- Empty reservoir
- Telemetry communication error
- Initialize alarm
- PPC not initialized
- Battery replacement
- Initialize to factory defaults
- Pump stopped
- Pump suspended
- Auto off
- Hourly maximum exceeded
- Pump alarm table
- Pump alarms
- CHAPTER 10 Troubleshooting Pump System Under-delivery
- CHAPTER 11 Medtronic MiniMed 2007C Implantable Insulin Pump System
Pump alarms
125
PPC not initialized
If the PPC is not initialized to a Pump, the following message is dis-
played:
When successfully completing a PPC initialization, the following mes-
sage is displayed:
Battery replacement
If the PPC main battery (AA 1.5V alkaline) has been replaced or the PPC
recognizes the “PUMP STATUS” needs to be checked, the following
message is displayed:
The user should reposition the PPC near the Pump, and then press SEL
and ACT. The PPC will communicate with the Pump.
NOTE: If while programming the PPC, the screen goes
blank, the PPC beeps six times and then the
“CHECK PUMP STATUS” message appears, the
battery needs to be replaced. (See Chapter 3 for
instructions, Install/Replace the Main Battery.)
PPC Display Type of Alarm
PPC
NOT INITIALIZED
1
PPC Display Type of Alarm
PUMP INITIALIZED 1
PPC Display Type of Alarm
CHECK
PUMP STATUS
1
Dmp9196021-011_c.book Page 125 Wednesday, April 3, 2002 5:06 PM