User's Manual

Cleaning your transmitter
Always refer to your transmitter user guide for instructions on cleaning the
transmitter.
Storing your pump
Storage mode allows you to safely place your pump in storage while not in use.
Note: If you place your pump in storage mode, it is important to insert a
new AA battery for 8 to 12 hours every six months to recharge the
internal power source.
WARNING: Active insulin is now cleared. Any active insulin tracked
prior to the pump entering storage mode is not included in any
new Bolus Wizard calculations.
Placing your pump in storage mode:
1. Remove the AA battery from the pump. For details, see Removing the battery,
on page 23.
Note: When you remove the battery, your pump issues an Insert
Battery alarm for 10 minutes or until you place your pump into
storage mode.
2. Press and hold
until your screen turns off.
Caution: Store your pump at room temperature. While in
storage, the pump should never be exposed to temperatures
above 35°C (95°F).
Waking your pump from storage mode
1. Insert a new AA battery into your pump. For details, see Inserting the battery,
on page 22.
242 Chapter 14
MP6025958-022 / A
RELEASED