User's Manual

To enter your Bolus Wizard settings:
1. When your pump shows a list of settings for the Bolus Wizard, make sure you
have the values you need before continuing.
2. Depending on the Carb Unit you set earlier, either the Carb Ratio or the Exch
Ratio screen appears. Enter your carb ratio or exchange ratio by entering the
End time and the Rate. You can adjust your carb or exchange ratio at any
time.
For details, see Changing your carb or exchange ratio, on page 69.
3. When the Edit Sensitivity screen appears, enter your insulin sensitivity factor
by entering the End time and the mg/dL per unit. You can adjust your insulin
sensitivity factor at any time.
For details about entering insulin sensitivity factors, including how to set
multiple time periods, see Changing your insulin sensitivity factor, on page 70.
4. When the BG Target screen appears, enter your BG Target range by entering
the End time and your Lo (low) and Hi (high) limits. You can adjust your BG
Target ranges at any time.
For details, see Changing your Bolus Wizard BG target, on page 70.
A message appears confirming that your setup is complete.
5. Select Next to display the Home screen, and continue using your pump.
Troubleshooting sensor issues
My pump cannot find the sensor signal
If your pump cannot find the sensor signal after you connect your sensor and
transmitter, follow the instructions on the pump screen to troubleshoot the issue
as described below.
If your pump finds the sensor signal at any time during troubleshooting, your
pump beeps or vibrates, and "Warm up" appears on your sensor graph. It can take
up to two hours for your sensor to warm up.
234 Chapter 13
MP6025958-022 / A
RELEASED