User's Manual

Title and text Explanation Next steps
Sensor signal not found
Did transmitter light blink
when connected to
sensor?
The pump has still
not received a
signal from the
transmitter.
When you reconnected the
transmitter to the sensor, did you
see a blinking green light on the
transmitter?
• Select Yes or No and follow the
instructions on the screen.
Sensor signal not found
See User Guide.
After multiple
attempts, the pump
failed to detect the
transmitter and is
unable to receive
sensor signal.
• Select OK to clear the alert.
• Repeat the connection process.
Remove the transmitter from the
sensor for about ten seconds,
and then reconnect it to the
sensor.
• It can take up to 15 minutes for
your pump to find the sensor
signal.
• Move your pump closer to your
transmitter to improve reception.
• Make sure you are away from
any electronic devices that might
cause interference, such as
cellular phones and other
wireless devices.
• If your pump still cannot find the
sensor signal, call your local
representative for assistance.
SG value not available
If problem continues, see
User Guide.
The sensor signals
are either too high
or too low.
• Select OK to clear the alert.
• You do not need to change the
sensor. If the alert persists, test
your transmitter with the tester.
Refer to your transmitter user
guide for instructions on testing
the transmitter.
224 Chapter 12
MP6025958-022 / A
RELEASED