User's Manual

Connecting the transmitter to the sensor
Always refer to your transmitter user guide for instructions on connecting the
transmitter to the sensor.
Starting the sensor
After you insert your sensor and connect your sensor and transmitter, your pump
starts communicating with the transmitter. The pump notifies you when the
sensor is ready to use.
To start a new sensor using the Start New Sensor message:
1. Select Start New Sensor when it appears on the pump screen.
The "Sensor warm-up started" message appears.
2. Select OK.
"Warm up..." appears on the Home screen until the sensor is ready for first
calibration.
Note: If you do not see the Start New Sensor option, then follow
the procedure for manual connection described below.
To start a new sensor using manual connect:
1. Go to the Sensor Connections screen.
Menu > Sensor Settings > Sensor Connections
2. Select Start New Sensor.
The Start New Sensor screen appears.
3. If you have not done so already, connect the transmitter to your sensor. For
details about connecting your transmitter and sensor, see your transmitter
user guide.
Your pump searches for your transmitter signal. It can take up to six minutes
for your pump and transmitter to start communicating.
4. Select OK.
5. The Sensor warm-up started message appears on the screen. Select OK.
182 Chapter 10
MP6025958-022 / A
RELEASED