User's Manual

If your pump does not connect to your transmitter:
1. If your pump does not connect to the transmitter, do one of the following:
• Select Retry to return to the Enter Device SN screen on your pump, and
then return to step 4 of the procedure above and follow the instructions
to search again.
• Select Cancel to return to the Connect Device screen, where you can
search again using Manual Connect or Auto Connect.
2. If you have tried to connect multiple times without success, see My pump
cannot find the sensor signal, on page 234.
Deleting the transmitter from your pump
Follow this procedure to delete the transmitter from your pump. Use this process
when you are replacing your transmitter.
To delete your transmitter from your pump:
1. Go to the Manage Devices screen.
Menu > Utilities > Device Options > Manage Devices
2. Identify and select your transmitter by the serial number. The serial number
can be found on the back of the transmitter.
3. Select Delete.
4. A screen appears confirming that you would like to delete the device. Select
Yes to confirm or No to cancel.
Inserting the sensor
Always refer to the serter user guide for instructions on how to insert the sensor.
■
setting up continuous glucose monitoring
Setting up Continuous Glucose Monitoring 181
MP6025958-022 / A
RELEASED