User's Manual

If your pump does not find your transmitter:
1. Place the transmitter back on the charger and make sure your transmitter is
fully charged before continuing.
2. Place your pump and transmitter within an arm's length of each other.
3. Select Retry on your pump and immediately remove the transmitter from the
charger to start the search process.
4. If the search is unsuccessful the second time, select Cancel when the No
Devices Found message appears and then follow the instructions in Wirelessly
connecting your pump and transmitter using Manual Connect, on page 178.
If your pump found multiple devices:
1. Write down the serial number for your transmitter. The serial number can be
found on the back of your transmitter.
2. Place the transmitter back on the charger and make sure your transmitter is
fully charged before continuing.
3. Select Next from the Multiple Devices Found message to display the Enter
Device SN screen.
4. Manually enter your device serial number by following the instructions,
starting with step 4 in Wirelessly connecting your pump and transmitter using
Manual Connect, on page 178.
Wirelessly connecting your pump and transmitter using
Manual Connect
The Manual Connect process requires you to enter the serial number of the
transmitter into your pump. Use this process if you are unsuccessful using the
Auto Connect process, or when multiple people in close range are connecting
their pumps with other devices, such as a group training session.
Note: You can connect only one transmitter to your pump. If you already
have a transmitter connected to your pump, you must delete it before
continuing. For instructions on deleting a transmitter from your pump,
see Deleting the transmitter from your pump, on page 181.
178
Chapter 10
MP6025958-022 / A
RELEASED