User's Manual

Delivering a bolus using Easy Bolus
Initially you should use the Easy Bolus feature while looking at the pump screen as
you count the tones or vibrations.
Caution: Always check your pump if you hear any unanticipated
beeps or vibrations.
Caution: When using Audio or Vibrate, it is possible that an Audio or
Vibration notification may not occur as expected if the speaker or
vibrator in your pump malfunctions. This is most important when
using the Easy Bolus feature or when your pump is in Manual Suspend
where a missed notification may cause an over or under delivery of
insulin.
Contact the 24 Hour HelpLine or your local representative with any
concerns.
To use the Easy Bolus feature, you need to put your pump into sleep mode by
pressing and holding the Menu button
for about two seconds.
To deliver a bolus using Easy Bolus:
1. While your pump screen is in sleep mode, press and hold
for about one
second. After your pump beeps or vibrates, release
. You can now start
programming your Easy Bolus.
Note: If your pump does not respond when you press , it may
not be in sleep mode, even if the screen is dark.
2. Press
the number of times needed to set your bolus amount.
Each time you press
, your pump sounds a tone or vibrates, and your bolus
amount increases by the number of units set for the step size.
Note: You cannot use to select the Easy Bolus values. Pressing
cancels the Easy Bolus.
84 Chapter 4
MP6025958-022 / A
RELEASED