Installation Guide

Trapeze Bed Mount Kit
Trapeze Base
MDS80615T
MDS80616T
ATTACHING TRAPEZE TO FLOOR BED/BASE END
BED END – Locate the lower bed bracket in the center of the bottom bed
frame with the tubular hook facing up. Secure the wing nuts to anchor
lower bed bracket onto bottom bed frame.
Base Assembly
Insert the upper base tube into the two sets of lower floor base tubes
until the spring pins are locked and rest them on the ground as the figure
shows. This is the lower base assembly.
Installing Upper Trapeze Section
1. Set the trapeze on a flat surface for easy installation of the top bed
bracket.
2. Loosen the wing nuts on the top bed bracket and push the bracket
approximately ¾ of the way up on the offset bar.
3. Tighten the wing nuts just enough to hold the top bed bracket in place
on the offset bar.
4. Place the trapeze assembly into the socket of the bottom bracket and
position the tubular hook of the bed bracket so that it rests on the top
rail of the floor bed/base end.
5. Securely tighten the wing nuts to anchor the top bed bracket to the top
rail of the floor bed/base end.
6. Adjust the position and/or height of the trapeze.
ADJUSTING THE TRAPEZE
Height
1. Place any of the lower chain links onto the “S” hook.
Position
1. Loosen the trapeze key by turning counter-clockwise.
2. Push the clamp to preferred location on the offset bar
3. Secure the trapeze clamp to the offset bar by turning key clockwise.
DO NOT assemble or use this equipment without first reading
and understanding this instruction sheet. If you are unable to
understand the Warnings, Cautions or Instructions, contact a
healthcare professional, dealer or technical personnel before
attempting to install this equipment; otherwise, injury or damage
may occur.
After assembly and BEFORE use, ensure that ALL attaching
hardware is securely tightened.
If, for any reason, a proper fit in installation cannot be achieved,
do not use and contact retailer where purchased for return
instructions.
Trapeze bar is intended to provide balance and support to a patient;
it is NOT intended to support an individual’s full body weight. Using
bar to support full body weight may result in product damage and
personal injury.
www.medline.com 1-800-MEDLINE
©2020 All rights reserved. Medline is a registered
trademark of Medline Industries, Inc.
Medline Industries, Inc., Three Lakes Drive, Northfield, IL
60093 USA
MDS80615T(PIC-00108)
Revision Date:20/08/20
WARNING
LIMITED WARRANTY
INSTALLATION / ASSEMBLY INSTRUCTIONS
NOTE: Check all parts for shipping damage. In case of shipping damage, DO NOT use. Contact carrier/dealer for further instruction.
(250 lb.)
Your Medline brand product is warranted to be free of defects in
materials and workmanship for a period of three (3) years from the
date of purchase. This device was built to precise standards and
carefully inspected prior to shipment. This limited warranty
is an expression of our confidence in the materials and workmanship
of our products and assures years of convenient,
dependable service. In the event of a defect covered by this warranty,
we will, at our option, repair or replace the device.
This warranty does not cover device failure due to owner misuse or
negligence, or normal wear and tear. The warranty does
not extend to non-durable components, such as rubber accessories,
which are subject to normal wear and replacement.
Non-durable components are warranted for 6 months. If you have a
question about your Medline product or this warranty,
please call us at 1-800-MEDLINE.
(Facing down)
(Facing Up)
(Facing Down)