Product Manual

ASSEMBLY INSTRUCTIONS

WARNING!

The lift is heavy. Therefore, avoid injury and DO NOT attempt to remove the lift from the box without

any assistance. Exercise care when unpacking and assembly to avoid injury and pinching ngers

between components. Read the owners manual carefully prior to unpacking and ask for assistance if

you are unsure of proper procedures. A set of special wrenchs is supplied with each lift for assembly;

or standard adjustable wrenchs or socket sets may be used.

Carefully remove all small boxes and parts containers from the shipping

container and check to ensure all parts are present.

Remove the base, set on the oor and engage the caster brakes.

Remove the bolts from the bottom of the mast and the base.

Pull the mast, boom, and spreader bar to an upright position.

Reinsert the bolts into the holes at the bottom of the mast and tighten the nuts.

Attach the control box hanging bracket to the mast and tighten the nuts.

Place the control box inside the bracket.

Attach the bottom of the actuator to the bracket on the mast and insert the pin.

NOTE: The actuator cable should be on the same side as the round openings

of the control box.

Attach the top of the actuator to the bracket on the boom and insert the pin.

Attach the spreader bar to the boom and insert the pin.

Insert the actuator plug into the control box.

Insert the pendant plug into the control box.

NOTE:

Prior to using the Medline MDS400EL for the rst time, charge the batteries

for 12 hours.