Product Manual

OPERATING INSTRUCTIONS

NOTE: Turn the lift “ON” by turning the red “RESET” button clockwise until it pops up. Turn

the lift “OFF” by pressing down the “RESET” button.

Transfer From Bed

• Resident should be laying  at in the center of the bed.

• Position the resident onto his/her side by gently rolling them towards you with the assistance of

another caregiver.

• Roll the sling in half, approximately. The handle on the back section should face outward when

the sling is  tted.

• Position the sling under the resident so the commode aperture or “U” shaped cut-out aligns

with the base of the spine and top of the sling close to the neck.

• Roll the resident onto the opposite side and position him/her on the  at section of the sling.

This will allow you to unroll the remainder of the sling from the other side of the resident.

• Once the sling has been positioned centrally, feed the leg sections under the thighs and draw

them up between the thighs.

• Raise the head of the bed if this function is available.

• Open the base legs and move the lift slowly towards the

resident and position the spreader bar over the resident’s

chest.

•

Attach Loop A of the sling to Hook A on spreader bar; attach Loop B to Hook B; attach Loop C

to Hook C; attach Loop D to Hook D. (Pass loops e and f through each other, crossing them

over each other and the attach to hooks E and F on the spreader bar)

• Lift the resident above the bed by using the hand control while watching and reassuring them.

• Pull lift away from bed.Close the base and move resident over the wheelchair (chair wheels

locked) or commode opening the base for stability and  t.Then lower the resident onto the

surface by pressing the down button.

NOTE: Reverse the above procedures when returning the user/patient to bed.

Transfer from Wheelchair

• Grasp the sling at each corner of the “U” shape of the commode aperture.

• The sling should be  tted with the loop handle on the back facing outward.

• Help the resident lean forward slightly, then slide the sling down between the chair and the

resident’s back.

• Position the commode aperture where the buttocks meet the seat.

• Position the sling equally around both sides of the body.

• Draw the leg sections to the front along the side of the resident’s thigh.

• Check the sling’s central positioning by comparing the lengths of the leg sections when they

are drawn forward.

• Reposition the sling if the leg sections are not equal in length.

• Feed the leg sections under the thighs.

• From between the legs, gently pull the leg sections up the inner thigh.

• Cross one leg loop through the other and then position the lift and attach all sling loops as

described in the “from the bed transfer” above.

Attach Loop A of the sling to Hook A on spreader bar; attach Loop B to Hook B; attach Loop C