User manual

8
Marking the time of going to bed and rising from bed – ABPM-05and BlueBP-05 only
If the DAY/NIGHT shift function is disabled during programming, the patient can press
the DAY/NIGHT button to mark the time of going to bed (in the evening) and rising from
bed (in the morning).
Manual DAY/NIGHT shift – ABPM-05 and BlueBP-05 only
If this function is enabled during the programming, the patient can manually shift the
measurement frequency period (day or night) by pressing the DAY/NIGHT button. The
switch is available in the two hour period before the prescheduled shift.
Bluetooth functions
You can initiate the Bluetooth mode by pressing the START and the EVENT buttons
simultaneously.
Switching to Bluetooth discoverable mode
The device switches to discoverable mode, making it connectable to all Bluetooth devices, by
pressing the two buttons simultaneously for longer than three seconds and then releasing
them. In this state the PC will connect to the device and you can read out the recorder data
of the last measurement or you can also programme the device for the next monitoring
session. After reading out or programming the Bluetooth connection is automatically ceased.
Switching off Bluetooth discoverable mode
You can switch off the Bluetooth mode by pressing the START and the EVENT buttons
simultaneously. The discoverable mode is automatically ceased if the connection fails to be
established in one minute.
5. Display
ABPM shows important status information, the processes and the results of individual
readings on its LCD. The most important displays are listed here, in addtion to these, a lot of
extraordinary situations and errors have their own code displayed on the LCD. These codes,
stored together with recorded data, will be listed in the device memory and can be displayed
by the software. Information displayed on each device:
Normal status: time is
displayed.
Pulse rate value of just
completed
measurements
(beats/minute)
Blood pressure
measurement initiated
(mmHg)
Event marker set
during a button push
Pumping for
measurement, current
pressure is displayed
(mmHg)
Error code display
Deflation during
measurement, current
pressure is displayed
(mmHg)
The device is switched
off.