User manual

If you wish to use a BlueBP-05 with Bluetooth under Windows XP SP 2, follow the steps

below. With other Windows versions, please refer to the documentation of the Bluetooth

device used in your computer.

a) Open the Tools - Options dialog of CardioVisions and select the Communication

category. Select the type of the recorder, then click on the appearing Bluetooth settings

button. In the appearing dialog, click on the Connect setup button to go to the next step.

b) In the appearing dialog you can see Meditech recorders which have already been added to

your computer. Place fresh batteries into the new BlueBP-05 recorder and make it

Bluetooth discoverable.

For this, in case of BlueBP-05, press the START and the EVENT button simultaneously for

longer than 3 seconds, then release them. The LCD displays the PC-- marking, indicating

the recorder is discoverable. The recorders remain discoverable for a minute then switches

back to stand by mode. If a recorder switches back to standby mode, make it discoverable

again. After you have made a recorder discoverable, click on the Add button.

c) If there is a moving torch on the screen, the PC searches for Bluetooth devices. Should a

recorder switch back to stand by mode due to a timeout, make it discoverable again then

click on the Add button.

After the search the found devices are listed. The name of the recorder in case of BlueBP-05

is BB5_xxxx, where xxxx is the last four digits of the serial number found on the back of

the recorder. After selecting the appropriate recorder, the OK button becomes active, please

click on it.

d) As authentication key (PIN), please enter the last four digits of the serial number. After

entering the PIN, click on the Finish button.

e) Wait until the system installs and configures the new Bluetooth device.

By clicking on the Test button you can check the communication. Make the recorder

discoverable before the test as described above.

Monitoring step by step

Before you begin, you should have the CardioVisions software properly installed and

configured on your computer, and the recorder correctly connected. To program your

ABPM-05 or ABPM-04 recorder, you will need a Meditech optical interface cable properly

connected to your computer's serial or USB port and the communication port correctly

selected in the CardioVisions software. To program BlueBP-05, you will need a properly

installed and connected Bluetooth dongle, and the communication correctly set in the

CardioVisions software.

Programming by using a PC

1. Inform your patient about the monitoring rules well in advance.

2. Programming:

Start the CardioVisions programme and select either ABPM-05, ABPM-04 or BlueBP-05

from the device types. Click on Device/Programming device.

3. Enter new patient data or select patient from the database.

4. Create monitoring plan adjusted to the patient’s daily routine.

5. Insert two (in case of ABPM-05 and BlueBP-05) or four (in case of ABPM-04) fully

charged, AA size batteries into the battery compartment and check their voltage.

6. Connect the recorder to the computer.

7. Send the monitoring plan from the computer to the recorder unit.