User's Manual

ETF-RD-BKQ-02. Instructions for Use (Rev.0)
Page12 / 27
2. Settings
█ Inserting (or Replacing) the Batteries
The batteries need to be inserted before using your Medisign KT26 BT blood β-ketone meter for the first time or
when the batteries are low. When the batteries are low the screen will display and blink the on the bottom
of the screen. It will be continuously shown until the meter becomes unusable due to low battery.
1. Open the battery compartment cover on the back of the meter.
2. Insert new batteries, with the (+) side facing up.
3. Replace the compartment cover back onto the meter.
CAUTION
IMPORTANT
NOTE:
 The meter can also be used with a single battery. If you install two (2) batteries, you can use it for a
longer period.
 Whenever replacing the batteries, you need to reset the current date and time. However, test results stored
will NOT be deleted.
█ Set Date and Time
Press button to turn on the meter.
Press the button to set the month, date, hours, minutes and year on after another. With the < or > button you
can change the flashing value.
• Risk of explosion if battery is replaced by an incorrect type.
• Small items such as the battery cover and batteries are choking hazards.
• Dispose of used batteries according to local regulations.
• If the meter is NOT to be used for a long time, remove the battery to eliminate the risk of battery leakage.