User Guide

20
3 Getting Started
GB
3.7
ON/OFF switch
I/0
3.6
Holder
3.5
Adjusting the
voice function
The time and date are normally set automatically by radio along with the time
signal. When no time signal is received, or it is too weak, the clock can also be
set manually.
1. The device is in stand-by mode. Press the START button

and MEM button

simultaneously to go to the quick setting mode for the radio clock. Now
press the START button

to go to the manual time setting mode.
2. The digit for entering the month flashes first. By pressing the START button

repeatedly, the digits for the day, hour and minute will flash in succession.
While each input position is flashing, press the MEM button

to enter the
corresponding digit. By holding the MEM button

the setting process can
be speeded up.
3. Exit the time setting mode by pressing the START button

while the minute
position is flashing. It will switch to stand-by mode.
After changing the batteries the clock will need to be reset, either automatically
by radio signal or manually by time setting mode.
The voice function can be adjusted with the device switched on ( ON/OFF
switch

in I position ), i.e. with just the date and time displayed. Press and
hold down the MEM button

until the selected language appears on the dis-
play (e.g. L1).
L0 = Language function switched off L4 = Dutch
L1 = German L5 = French
L2 = English L6 = Italian
L3 = Spanish L7 = Portuguese
The device speaks the language setting, and changes the display and the an-
nouncement to the next language if the MEM button

is held down. The
selected language can be changed by releasing the MEM button

as soon
as the language that you require is displayed or spoken. The selected volume,
which is indicated by flashing bars, can be modified by pressing the MEM
button

again and holding it down until the required volume is indicated –
the higher the bar, the louder the volume. Release the MEM button

to
confirm your selection. The bar stops flashing and the display switches back to
the time display.
Using the holder included with the unit you will store the arm cuff and the air
hose together with the device. First attach the adhesive pad to the rear side of
the unit, then fix the holder on it firmly.
Your device has a touch screen as an equipment. Be careful not to touch the
display by mistake. Keep the ON/OFF switch

in 0 position when the device
is not in use to avoid unintentional adjustments.
3.4
Setting the date
and time
51145_MTD_West_FINAL.qxd:Blutdruckmessgerät 21.10.2009 17:06 Uhr Seite 20