Instruction manual

3 Operating

Once the heads reach this point, the direction of rotation is reversed

again and then travel up the back again. Press the button again to de-

activate the Shiatsu massage function.

Spot massage button (▲▼) i

Switch on the device by pressing On/Off button . Only under shiatsu

state spot massage for back will response. Activate the Shiatsu function

state by pressing the Shiatsu massage button . Massage heads rota-

te in a spot. Pressing and holding the spot massage button changes

position of massage heads upward or downward. Press ▲ or ▼ until the

desired position is reached, loose the button . Press button again

to de-activate the spot massage function and return to Shiatsu state.

Rolling massage button i

Switch on the device by pressing On/Off button . Activate the Rolling

massage function by pressing the Rolling massage button . Select the

region you wish to massage with the back massage button ( / / ).

zui

Width button ( ) i

This button is effective only in the rolling massage state. Press the rolling

massage button to activate the rolling massage function. Pressing and

holding the width button , the distance between the rolls increases or

decreases until the desired width is reached and you loose the button .

Heat button i

The heat function can be activated at any time with the shiatsu massage

and rolling massage, during which the vibration massage can also be

activated. Press the heat button to activate the function; the LED on

the control unit and the massage heads light up red. The heat is radiated

through the massage heads . Press button again to de-activate the

heat function; the LED and the red light of the massage heads go out.

▼

Lower button (lower back) i

The massage rolls travel up and down the lower half of the back. The

reversal of the direction takes place when the respective end positions are

reached. i

Upper button (upper back) i

The massage rolls travel up and down the upper half of the back. The

reversal of the direction takes place when the respective end positions are

reached. i

Full button (full back) i

The massage rolls move from the “Park” position at the base of the

backrest, up to the shoulder area, massaging the back whilst doing so.

Once the uppermost position has been reached, the direction of the mas-

saging rolls is reversed. The heads then travel down to the base of the

backrest. Once the heads reach this point, the direction is reversed again

and then travel up the back again. i

Press the button again to de-activate the rolling massage function;