User manual

42
4.4
Starting
application
Make sure that the skin areas to be treated are shaved, dry, clean and
free of creams, deodorants etc. Proceed as follows:
1. Carry out steps 1 and 2 from chapter 4.2 “Skin test”.
2. Set the intensity that you have tested and which is suitable for your
skin, by pressing the ON/OFF button
1
briey in succession so
long, until the desired intensity (Level 1 to 5) is lit on the intensity dis-
play
2
.
3. Place the light area
6
onto the skin and press the trigger button
8
to
trigger a light pulse. The skin contact area
7
must lie fully on the skin
(the readiness indicator
3
starts to ash green), so that a light pulse
can be emitted by the device. When the pulse is emitted, you will see
a bright ash and may hear a clicking sound.
4. Now place the device on another area of the skin while it charges for
the next light pulse.
5. Then emit a new light pulse on the other skin area.
6. Repeat this procedure for other planned skin areas.
7. Switch the device off by pressing and holding the ON/OFF button
1
.
WARNING
• Never emit several light pulses in succession onto the same
area of skin!
• If pain, swelling or other unusual reactions occur during the
application, immediately stop the test and do not carry on
using the device. Contact your doctor.
4 Operating
GB