User manual

S
S
A
A
F
F
E
E
T
T
Y
Y
A
A
N
N
D
D
S
S
E
E
R
R
V
V
I
I
C
C
E
E
3
Française English Nederlands Dansk Español Deutsch
CONNECTING
POWER SUPPLY
• Do not open the power adapter housing.
When the housing is open there is a danger
of severe electric shock. It contains no user-
serviceable parts.
• The power socket must be in the vicinity of the scanner
and within reach of the power adapter cables. DO NOT
stretch the power cables tightly to reach a power socket.
• To disconnect your scanner from the power source re-
move the power cord from the power socket.
• Only use the power adaptor provided with this flat bed
scanner (DSA-0151A-12UP or HDAD15W101-124) op-
erating at AC 200-240V~/50 Hz.
• If using an extension cord, make certain that it meets
your local safety requirements. If in doubt, consult a
qualified electrician.
• To provide additional protection against electric shock, power
surges, lightning strikes, or other electrical damage to your
scanner, we recommend the use of a surge protector.
Observe the following instructions to connect your flat bed
scanner properly:
• Route the cable so that no one can step on it or stumble over it.
• To avoid damage to the cable do not place any objects
or furniture on the cable.
• Please unlock the scanner before use. When you intend
to transport the scanner lock it again. (see page 7)