User manual

4. CONNECTING TO THE PC

Make sure your scanner software has been installed already

(see page 7). Connect your flat bed scanner as follows:

1. Switch on the computer and all connected peripheral equip-

ment (monitor, printer, external hard drive, etc.) and wait

until the operating system has booted completely.

2. Connect one end of the USB cable (n) to a free USB connec-

tion socket on your computer (o) and the other end to the

scanner.

3. Windows

will then recognise that a new piece of hardware

has been connected and complete the installation procedure.

Do not interrupt this setup procedure.

Note: If your operating system is configured so that the instal-

lation procedure accepts only signed drivers and software (the

default) an information screen will appear. Although the soft-

ware lacks the digital signature it may still work properly.

Click on “Tell me why this testing is important” to get de-

tailed information. Confirm by clicking on “Continue

Anyway”.