Technical data

S
S
A
A
F
F
E
E
T
T
Y
Y
A
A
N
N
D
D
S
S
E
E
R
R
V
V
I
I
C
C
E
E
3
CONNECTING
POWER SUPPLY
• Do not open the power adapter housing. When the
housing is open there is a danger of severe elec-
tric shock. It contains no user-serviceable parts.
• The power socket must be in the vicinity of the scanner and
within reach of the power adapter cables. DO NOT stretch the
power cables tightly to reach a power socket.
• To disconnect your scanner from the power source remove the
power cord from the power socket.
• To avoid power consumption when the device is switched off
either pull out the power plug when the device is not used or
connect the device to a master-/slave power bar.
• Only use the power adaptor provided with this flat bed scanner
(HDAD15W101-124) operating at AC 200-240V~/50 Hz.
• If using an extension cord, make certain that it meets your lo-
cal safety requirements. If in doubt, consult a qualified electrician.
• To provide additional protection against electric shock, power
surges, lightning strikes, or other electrical damage to your scan-
ner, we recommend the use of a surge protector.
Observe the following instructions to connect your flat bed scan-
ner properly:
• Route the cable so that no one can step on it or stumble over it.
• To avoid damage to the cable do not place any objects or
furniture on the cable.
• Please unlock the scanner before use. When you intend
to transport the scanner lock it again (see page 9).