Specifications

Safety Connecting Operation Help Appendix
- 17 -
Getting Started
The software on this PC comes fully pre-installed. You do not have to load any of
the CD's/DVD’s supplied. With many programs (for example, telephone-CD's or
encyclopedias), however, it is necessary to insert the corresponding CD/DVD in
order to call up the data which is stored on it. The software will ask you to do this as
necessary. Once you have made all the connections and secured the necessary
connectors you can turn on the monitor, the other peripherals and finally the PC
itself.
Starting up the PC
1. Turn on the monitor and any peripheral devices you have connected.
2. Set the on/off switch on the back of the PC to "I" if it is
not already set (diagram reference: M)
3. Briefly press the on/off switch on the front of the PC.
(diagram reference: D)
You can program the function of the main switch in the power management
of Windows
®
(please refer to on-line help). The PC will always be switched
off, if the main switch is pressed for more than 4 seconds.
Warning!
If the operating system is not shut down properly (through á Ö Shut
Down), there is a risk of data loss.
The PC and Windows
®
operating system starts and now goes through a number of
phases:
Note
Ensure that there is no bootable CD (for example, the Recovery-CD)
in the CD-ROM drive. Such discs will prevent the operating system
from loading directly from the hard drive.
The operating system is loaded from the hard disk. During the initial set-up, the
loading process takes slightly longer than normal to register the operating system
and the individual components completely. Your operating system is finished loading
when a welcome screen is shown on your display.
Follow the instructions on the screen. Dialogue boxes will explain any steps that
need to be taken.
Should you have any questions just click on
.