Specifications

CHAPTER 2 HARDWARE INSTALLATION

2-26

2.20 Modem Wake Up Connector: JMDM1

The JMDM1 connector is for used with Modem add-on card that supports

the Modem Wake Up function. To use this function, you need to set the

“Power On by Ring” to enable at the BIOS Power Management Setup.

Note: Modem wake-up signal is active “low”.

PIN SIGNAL

1NC

2 GND

3 MDM_WAKEUP

4NC

5 5VSB

Note: To be able to use this function, you need a power supply that

provide enough power for this feature.

(Power supply with 750mA 5V Stand-by)

JMDM1