Instruction manual

22 of 40
Telephone: [phone]
Internet: www.medion.com.au
After Sales Support
6. First steps
6.1. Switching the camera on/o
 Hold down the POWER button for 2 seconds. The
camera will vibrate briefly 3 times (2 short, 1 long)
to signal that the device is now switched on.
The operating LED will light up blue when the
device is switched on.
 In order to turn the camera off again, hold down
the POWER button once again. The camera will
vibrate briefly once to signal that the device has
been switched off. The operating LED will go out.
NOTE!
If the camera does not switch on, check
if the battery is charged.
6.2. Fixing the camera in the
mount
 Clamp the camera into the camera mount.
 Lock the camera mount by pulling the clamping
lever downwards.
 Depending on the type of use, select a suitable
mount and push the camera mount into the slot
until it audibly clicks into place.
86692 50044461 EN ALDI AUS Content final.indd 2286692 50044461 EN ALDI AUS Content final.indd 22 17.09.2013 07:55:3117.09.2013 07:55:31