Instruction manual
English - 55 -
TV and Operating Buttons
FRONT and REAR VIEW
Control Buttons VIEW
Control Buttons
Up direction1.
Down direction2.
Programme/Volume / AV 3.
/ Standby-On selection
switch
Note:You can move the switch,
upward or downward to change
the volume. If you want to change
channels, press the middle of the
switch once (Position 3) and then
move upward or downward. If you
press the middle of the switch once
more, source OSD will be displayed.
If you press the middle of the switch
and hold about a few seconds, the
TV will switch to standby mode. Main
menu OSD cannot be displayed via
control buttons.
Viewing the Connections - Back Connectors
HDMI 1
SPDIF
Coax.OUT
12V
DC IN
HDMI 1: HDMI Input 1.
HDMI Inputs are for connecting a device that has a HDMI socket. Your TV is capable of displaying
High Denition pictures from devices such as a High Denition Satellite Receiver or DVD Player. These
devices must be connected via the HDMI sockets or Component Socket. These sockets can accept
either 720p or 1080i signals. No sound connection is needed for a HDMI to HDMI connection.
RF Input2. connects to an aerial antenna system.
Note: If you use a decoder or a media recorder, you should connect the aerial cable through the device
to the television with an appropriate antenna cable, as shown in the illustration in the following pages.
SCART 3. input or output for external devices. Connect the SCART cable between the SCART socket on the
TV and the SCART socket on your external device (such as a decoder, a VCR or a DVD player).
Note: If an external device is connected via the SCART socket, the TV will automatically switch to AV
mode.
Note: S-VHS signal is supported via the scart socket.
VGA Input4. is for connecting a personal computer to the TV set.
Connect the PC cable between the PC INPUT on the TV and the PC output on your PC.
Note: You can use YPbPr to VGA cable (not supplied) to enable YPbPr signal via VGA input.
WARNING: You cannot use VGA and YPbPr at the same time.