Specifications

POINT OF USE

• Keep your LCD monitor and all units connected to it away from moisture and avoid dust, heat and

direct sunlight. Failure to observe these instructions can lead to malfunctions or damage to the LCD

monitor.

• Place and operate all units on a stable, level and vibration-free surface in order to avoid the

LCD monitor from falling.

• Avoid dazzle, reflections, extreme light/dark contrast in order to save your eyes and

ensure a pleasant, ergonometric work station.

• Take regulator breaks when working with your LCD monitor in order to avoid tension and

fatigue.

ENVIRONMENTAL CONDITIONS

• The LCD monitor can be operated at an ambient temperatures of between +41°F and +95°F

(5° C to 35° C) and at a relative humidity of between 20% and 85% (without condensation).

• When switched off, the monitor can be stored at between -4°F and +140°F (-20° C - +60° C), up to

the maximum height of 39,000 ft (12,000 m) above sea level at a relative humidity of between 20%

and 80% (without condensation).

• After transporting your LCD monitor please wait until it has assumed the ambient temperature

before connecting and switching it on. Extremely high variations in the temperature or humid-

ity may result in condensation forming on the inside of the LCD monitor which could cause an

electrical short-circuit.

CONNECTING

Observe the following instructions to connect your LCD monitor properly:

POWER SUPPLY

• Please pay attention: Pats of the device are still live, even if the mains switch is

switched off. Pull the mains plug out of the socket, to interrupt the power supply to

your LCD monitor or to release the device from voltage completely.

• Operate your LCD monitor mains (power supply) only on grounded sockets with AC 100-240V~/ 50-

60 Hz. If you are not sure about the power supply at your location, check with your power company.

• For additional safety we recommend use of an excessive voltage protection device to protect

your LCD monitor from damage resulting from voltage surges or lightning.

• To interrupt the LCD monitor from mains (power supply) disconnect the plug from the socket.

• The power socket must be in the vicinity of your LCD monitor and within reach of the power ca-

bles. DO NOT stretch the power cables tightly to reach a power socket.

• If you use an extension cable, ensure that it fulfills the VDE requirements. Please ask your

electrician.

• You should lay the LCD Monitor cables in a manner that no one can trip or step on it.

• To avoid damage of cable do not place any objects or furniture on the cable.

• Your device has an On and Off switch. The LCD monitor can be switched on or off by means of it.

No electricity is consumed if the switch is at OFF (0).