Operating instructions

English 2
Safety and Precautions
Operating Safety
• Do not allow children to play unattended on electrical equipment. Children may not always correctly recognize danger.
• Keep the packing materials, such as foil away from children. The danger of suffocation could arise in the case of
misuse.
• Never open the housing of the TFT display (electric shock, short-circuit and the danger of fire)!
• Do not insert any objects through the slots and openings into the inside of the TFT (electrical shock, short-circuit and
the danger of fire)!
• Slots and openings in the TFT display are for ventilation purpose. Do not cover these openings, as otherwise this may
lead to overheating (overheating, danger of fire)!
• Never exert pressure on the display. This could break the display.
• An injury hazard exists when the display breaks. Wear protective gloves to pack the broken parts and send them into
your service center for proper disposal. Then wash your hands with soap, because it is possible for chemicals to escape.
• Do not touch the display with your fingers or with sharp objects to avoid damage.
Please proceed as outlined in the Customer Service section:
• if the power cable overheats or is damaged
• if liquid has gotten into the display
• if the TFT display is dropped or the housing damaged
Point of use
• In the first hours of operation, new devices may emit a typical, unavoidable but completely harmless smell, which will
decline increasingly in the course of time.
We recommend you to ventilate the room regularly, in order to counteract the formation of the smell. During the
development of this product, we have made sure that the applicable limits are clearly fallen below.
• Keep your TFT display and all units connected to it away from moisture and avoid dust, heat and direct sunlight. Failure
to observe these instructions can lead to malfunctions or damage to the TFT display.
• Do not operate your device in the open air, because external influences, such as rain, snow, etc. could damage the
device.
• Do not place any containers filled with liquid (vases or similar containers) on the device. The container could tip over
and liquid can impair electrical safety.
• Do not place any open sources of fire (candles or similar objects) on the device.
• Pay attention to sufficiently large clearances in the wall cupboard. Maintain a minimum clearance of 10 cm around
the device for sufficient ventilation.
• Place and operate all units on a stable, level and vibration-free surface in order to avoid the TFT display from falling.
• Avoid dazzle, reflections, extreme light/dark contrast in order to save your eyes and
ensure a pleasant, ergonometric work station.
• Take regulator breaks when working with your TFT display in order to avoid tension and
fatigue.
Repair
• Leave all repairs of your TFT display to authorized and qualified personnel only.
• Should a repair be necessary, please contact one of our authorized service partners only.
Intended Environment
• The TFT display can be operated at an ambient temperatures of between +41°F and +95°F
(5° C to 35° C) and at a relative humidity of between 20% and 85% (without condensation).
• When switched off, the display can be stored at between -4°F and +140°F (-20° C - +60° C), up to the maximum height
of 39,000 ft (12,000 m) above sea level at a relative humidity of between 20% and 80% (without condensation).
• After transporting your TFT display please wait until it has assumed the ambient temperature before connecting and
switching it on. Extremely high variations in the temperature or humidity may result in condensation forming on the
inside of the TFT display which could cause an electrical short-circuit.