Operating instructions

E
E
N
N
G
G
L
L
I
I
S
S
H
H
2
Safety and Precautions
Operating Safety
Do not allow children to play unattended on electrical equipment. Children may not always
correctly recognize danger.
Keep the packing materials, such as foil away from children. The danger of suffocation
could arise in the case of misuse.
Never open the housing of the TFT monitor (electric shock, short-circuit and the danger of
fire)!
Do not insert any objects through the slots and openings into the inside of the TFT (elec-
trical shock, short-circuit and the danger of fire)!
Slots and openings in the TFT monitor are for ventilation purpose. Do not cover these open-
ings, as otherwise this may lead to overheating (overheating, danger of fire)!
Never exert pressure on the display. This could break the monitor.
An injury hazard exists when the display breaks. Wear protective gloves to pack the broken
parts and send them into your service center for proper disposal. Then wash your hands with
soap, because it is possible for chemicals to escape.
Do not touch the display with your fingers or with sharp objects to avoid damage.
Please proceed as outlined in the Customer Service section:
if the power cable overheats or is damaged
if liquid has gotten into the monitor
if the TFT monitor is dropped or the housing damaged
Point of use
In the first hours of operation, new devices may emit a typical, unavoidable but completely
harmless smell, which will decline increasingly in the course of time.
We recommend you to ventilate the room regularly, in order to counteract the formation of the
smell. During the development of this product, we have made sure that the applicable limits
are clearly fallen below.
Keep your TFT monitor and all units connected to it away from moisture and avoid dust,
heat and direct sunlight. Failure to observe these instructions can lead to malfunctions or
damage to the TFT monitor.
Do not operate your device in the open air, because external influences, such as rain, snow,
etc. could damage the device.
Do not place any containers filled with liquid (vases or similar containers) on the device.
The container could tip over and liquid can impair electrical safety.
Do not place any open sources of fire (candles or similar objects) on the device.
Pay attention to sufficiently large clearances in the wall cupboard. Maintain a minimum
clearance of 10 cm around the device for sufficient ventilation.
Place and operate all units on a stable, level and vibration-free surface in order to avoid
the TFT monitor from falling.
Avoid dazzle, reflections, extreme light/dark contrast in order to save your eyes and
ensure a pleasant, ergonometric work station.
Take regulator breaks when working with your TFT monitor in order to avoid tension and
fatigue.