Software Manual
Table Of Contents
- Chapter 1. Introduction
- Chapter 2. Manual installation and start-up
- Chapter 3. Installation and start-up using the GoPal® Assistant
- Chapter 4. Basics of operation
- Chapter 5. Adjusting the Settings
- Chapter 6. Operating the GoPal® navigation software

Introduction
5
• Please note that your navigation device must be set to the local time zone to be able to calculate
the correct time of arrival for future route calculations.
• You can also follow your current position on the map without entering a destination. If available,
the name of the street you are currently on will be displayed
• Note that temporary local changes and/or restrictions to road traffic regulations (e. g. permitted
maximum speed) cannot be accounted for in the route planning: Always obey signage and/or
local traffic routing.
• Please note that the map material is current as of the time of delivery. However, the
manufacturer cannot guarantee the information to be completely binding or that it corresponds to
the road layout and/or signage.
Trademarks
All trademarks appearing in this manual and any brands or trademarks protected by third parties
are subject without restriction to the conditions of the applicable trademark law and the right of
ownership of the respective registered owners. All trademarks, trade names or company names
used here are or can be trademarks or registered trademarks of their respective owners. All rights
not expressly granted here are reserved.
The absence of an explicit name of the trademarks used in this manual does not mean that a
name is free and clear of third party rights.
• Windows
®
, Windows XP
®
, Windows 2000
®
, Windows Vista
TM
and ActiveSync
®
are trademarks of
the Microsoft
®
Corporation.
• Acrobat
®
and Acrobat
®
Reader
®
are trademarks of Adobe
®
Systems Incorporated.
Copyright and Warranty
Copyright © 2008
Version 4
All rights reserved.
Any information in this manual may be changed without notice and in no way represents any
obligation on the side of the manufacturer. The manufacturer accepts no responsibility for loss or
damage as a result of information or potentially incorrect information contained in this manual.
We are grateful for any information regarding errors and for suggestions for improvement in order
to offer you even more efficient products in the future.
This manual may not be reproduced, in whole or in part for any purpose and it may not be stored
to an electronic medium or reproduced in any other form including electrically, optically,
chemically, by photocopy or audio recording without the express, written consent of the
manufacturer.