Software Manual

Adjusting the settings
25
another opportunity to familiarise yourself with your navigation system by way of a brief
introduction after the navigation software starts: You can also skip this step and start operating
your navigation system immediately, as required.
Specific settings for the navigation software
Following start-up your navigation system functions with standard settings which can, however, be
changed and adapted to your personal needs in the Settings menu at any time. Open the Settings
menu by pressing the button, available on the main screen of the menu view.
Tip
If you want to accept the default settings of your navigation system or have already
made your personal settings, you can skip the following pages and go directly to Chapter
6, Operating the GoPal® navigation software.
Choose from the following setting menus:
• Route options
• Display
• TMC settings
• Program settings
• Configure special destination
• Device settings
• Help
The following describes the available setting menus as well as the setting options available there.
You can change the chosen settings again at any time.
Adjusting the route options
This sub-menu allows you to adapt the route calculation and navigation to your current personal
needs. Note that the route options can affect each other: Depending on the selection of route type,
other route options will be automatically deactivated.
The following options are generally available for selection:
• Route calculation has been optimised for cars (default). Road traffic regulations are in effect
for this setting: This means that all roads may generally be used; however one-way streets may
only be driven on in the proper direction of travel. As a rule, pedestrian zones are not directly
accessible and a corresponding message is emitted.
As an alternative to the default setting you can choose one of the following options: