Operation Manual
Table Of Contents
- 1. About these operating instructions
- 2. Safety information
- 3. Package contents
- 4. Setting up the PC
- 5. Connecting
- 5.1. Connecting the cables
- 5.2. Opening and closing the front cover (optional)
- 5.3. Connecting the monitor (optional)
- 5.4. Connecting an HDMI device (optional)
- 5.5. Connecting devices with mini HDMI connection (optional)
- 5.6. Touchscreen (optional)
- 5.7. Connecting USB devices (optional)
- 5.8. Connecting PS/2 devices (optional)
- 5.9. Connecting the audio output / headphones / speaker boxes
- 5.10. Connect microphone (optional)
- 5.11. Connecting audio input / recording source
- 5.12. Connecting the network (LAN)
- 5.13. Connecting S-ATA devices (optional)
- 5.14. Illumination (optional)
- 5.15. Connecting power supply
- 6. Starting up for the first time
- 7. Mouse
- 8. Keyboard
- 9. Hard drive
- 10. Optical drive (optional)
- 11. Card reader (optional)
- 12. Graphics system
- 13. Sound system
- 14. USB connection (optional)
- 15. Network operation
- 16. Settings
- 17. FAQ - Frequently Asked Questions
- 18. Customer service
- 19. Transport
- 20. Cleaning and care
- 21. Upgrading/modifying and repair
- 22. Recycling and disposal
- 23. Information about the scope of delivery
- 24. Legal Notice
- 25. Index

19 of 44
6. Starting up for the first time
The operating system and all hardware drivers are pre-installed. You do not need to
install any of the discs supplied.
For some programs (e.g. telephone CDs or encyclopaedias), it may be necessary to
insert the relevant disc to call up the data stored on it. The software will prompt you
to do this if necessary.
Once you have made all of the connections and screwed on all of the required con-
nections, you can start up your PC:
6.1. Starting up your PC
` Switching on the monitor.
` Switch on the mains switch by moving it to the setting I. (Set this switch to 0 to
disconnect the power supply.)
` Press the On/Off switch once to switch on your PC.
Your PC will now start and run through various steps.
PLEASE NOTE!
There should be no bootable disk (e.g. the recovery
disc) in the optical drive as this will prevent the operat-
ing system from being loaded from the hard drive.
The operating system will be loaded from the hard disk drive. The loading process
takes a little longer during the initial setup. Once all the necessary data has been en-
tered, the operating system will be set up. The operating system is fully loaded once
the Windows® start-up screen appears.
PLEASE NOTE!
Data loss!
The initial installation may take a few minutes. Do not
disconnect the PC from the power supply during initial
installation and do not switch it off. This may adverse-
ly affect the installation. Only switch off the PC when
installation has been successfully completed and the
start screen appears.
` Follow the instructions on the screen. Step-by-step instructions will guide you
through the process to be followed.
` The welcome procedure takes you through several screens and dialogues.
` Choose your required language and then the country you require.