Technical data

Helpline No. UK/ North Ireland 0871 37 61 020 Rep. Ireland 1-800-992 508
Web Support www.medion.co.uk
Model Number: 83388
20
Command timer
The clock must be set for this timer.
You can use the command timer to program a function that is to run automatically at a
particular time within the next 24 hours. The command series can contain up to four
commands, the first command must always be the selection of a mode key.
The following keys are not available for the remaining three commands: the mode keys,
the joystick (arrows and OK), MACRO, SETUP, EXIT.
You can create four command timers (Timer 1, Timer 2, Timer 3, Timer 4).
When the command is run this timer is automatically deleted.
Program the command timer
Example: This is how to program a command timer to control a recording on a DVD
recorder.
1. Keep the Setup key pressed down for approx. 3 seconds,
until
CODE SETUP appears.
2. Press Setup briefly twice more to open TIMER SETUP.
3. Press OK" The
SLEEPTIMER TV menu is displayed.
4. Use the arrows to select
the TIMER 1 SETUP menu
3
.
5. Press OK" The TIMER 1 SET display appears.
6. Press OK" The time when the command will be run appears.
The hours flash.
7. Use the arrows to set
the hour and confirm by
pressing OK.
The minutes flash.
8. Use the arrows to set
the minutes and confirm by
pressing OK.
9. The
TIMER 1 MODE? display prompts you to enter the
command. Use the mode key to select the device on which
the command should be performed.
In our example, DVD if the DVD recorder was programmed
on this key.
10. Press OK. You are prompted to make the first entry
TIMER 1
KEY1
. Enter the first command.
In our example: Use the number keys to select the
programme.
If no other input is needed, press OK or EXIT.
3
If a command timer has already been entered, then TIMER 2, 3 or 4 appears here.