Technical data

PREPARING DISCS FOR RECORDING

Cancel a Scheduled Recording

• Press SETUP on your remote control to enter the setup menu. Use the

buttons to select the “Record” menu, then press the button to enter the

menu, next use the buttons to select “Schedule Record”, finally press

the button to enter the menu.

• Use the buttons to move the cursor to the number of the recording that

you would like to cancel.

• Press

CLEAR on your remote control.

• Confirm that you would like to cancel this recording by using the but-

tons to select the green arrow to perform the operation or the red X to can-

cel.

Troubleshooting Scheduled Recordings

Your DVD recorder will not be able to perform the scheduled recording if:

1. No disc is loaded.

2. The disc is write-protected.

3. The disc is not the correct format (DVD+R or DVD+RW).

4. The disc already contains 49 titles. This is the maximum num-

ber of titles that can be recorded to a single disc.

5. Another recording is in progress.

6. The DVD recorder’s Time and Date is not set properly.

7. The time set for your recording is in the past.

8. The 8 memory slots for setting recordings are already filled.

9. There is no signal from the selected input source (it may be

connected incorrectly or turned off).

The DVD recorder will not be able to tell if a disc is damaged. Even if the re-

cording seems to be working, you may not be able to play back the disc if it

has been scratched, smeared, or otherwise damaged.

Manual Disc Recording

Place an initialized DVD+R or DVD+RW disc in the DVD recorder.

• Select the channel you want to record.

• Press

MONITOR on the remote to switch to external input mode.

• Press SOURCE to select the input source that you want to record. Press

SOURCE multiple times to cycle through the options: CVBS1 > CVBS2 >

S-VIDEO01 > S-Video02 > CHANNEL

• Press

RECORD on the remote control or the front panel of the DVD recor-

der to start recording.

• Press

STOP to stop recording. Please wait 15-17 seconds while your re-

cording completes.

• Press MONITOR to switch to DVD mode. The recorded title will appear on

the screen. Press ENTER to view your recorded video.

After recording, the following messages will also be stored:

• Record date and channel source.