Technical data

DVD-RECORDER 80032 31
PREPARING DISCS FOR RECORDING
• Confirm your settings: Use the buttons to move the cursor to the green
arrow to confirm and save settings or the red X to cancel settings. Press
ENTER to confirm.
When you are done, press
SETUP again to leave the setup menu.
Note:
Turn off recorder prior to the start of your scheduled program. If unit
is left on the scheduled programs will not record.
Stop an In-Process Scheduled Recording
• While the record is proceeding, press STOP to stop recording and go to
DVD mode, or press
POWER to stop recording and go to stand-by status.
Recording Quality
You can record discs using five different quality levels. The higher the quality
level, the more space (time) will be taken up on your disc. Press
REC QUA-
LITY
on your remote to change the quality settings.
HQ (High Quality):
The best picture quality 60 min. / 1 hour
SP (Standard Play):
Excellent (DVD video) picture quality 120 min. / 2 hours
LP (Long Play):
Good (S-VHS) picture quality 180 min. / 3 hours
EP (Extended Play):
Better than VHS quality 240 min. / 4 hours
SLP (Super Long Play):
VHS picture quality 360 min. / 6 hours
Recording times are estimates, actual recording times may vary. Please note
that if your source video is of low quality, then your final recording will be of
low quality even if you select a higher quality recording level. Recording over
previously recorded discs may also decrease the quality level.
Correct a Scheduled Recording
• Press SETUP on your remote control to enter the setup menu. Use the
buttons to select the “Record” menu, then press the button to enter the
menu, next use the buttons to select “Schedule Record”, finally press
the button to enter the menu.
• Use the buttons to move the cursor to the number of the recording that
you would like to correct. Next press the button to make corrections.
• Use the buttons to move the cursor to the information that you would
like to correct, then, use either the buttons or #’s 0-9 on the remote to
enter the correct value.
• Confirm your settings: Use the buttons to move the cursor to the green
arrow to confirm and save settings or the red X to cancel settings. Press
ENTER to confirm.