User's Manual

5
Do not use the camera near radio transmitters or high-voltage
lines.
Never leave the camera and the battery in a car or on a car hood
in the summer. Doing so may cause leakage of the battery
electrolyte, overheating, fire, or a battery explosion due to the
high temperature.
If the camera gets wet, do not attempt to dry with a heater,
microwave, autoclave, or UV light.
Do not extend the supplied cables. Do not keep the power cord
near any heat source.
Plug of the power adapter is the disconnect device from the
Mains power source. When the camera is not in use, please
disconnect the power plug and keep it in a safe place.
The eye cannot be exposed to the illumination light at operation.
Please remove the battery if the device is not in use for a long
time.
Before use the device, please make sure that the voltage of the
power supply meets the product specifications.
The product needs to be installed in a location where it can be
easily unplugged its power.
The performance criteria of the following description were
accepted when operating the device: short-term function
abnormal but can be resumed after restarting without operator
intervention. Unless basic safety cannot be achieved.
Caution – Use of controls or adjustments or performance of
procedures other than those specified herein may result in
hazardous radiation exposure.
Complies with FDA performance standards for laser products
except for conformance with IEC 60825-1 Ed. 3., as described in
Laser Notice No. 56, dated May 8, 2019.
Charging the battery
The time required for charging varies depending on the
conditions of battery usage. Charging takes longer at high or