Owner Manual

User Manual
User Manual
Change filter
Indicator Icon
2. Turn off the power, pull out the
power plug to reduce the risk of electric
shock. This equipment has a polarized
plug (one blade is wider than the other).
This plug will fit in a polarized outlet only
one way. If the plug does not fit fully in
the outlet, reverse the plug. If it still does
not fit, contact qualified personnel
to install the proper outlet. Do not alter
the plug in any way.
3. Press tabs in each side cover and pull
the cover. Then lift each cover and pull
out slightly.
4. Remove all existing filters from
the unit.
5. Remove all packaging from new
filter sets. Then, install the new filters
into the unit in the same order as
existing filters.
6. Install new filter sets in the unit.
Operating Steps
1. The machine will remind user to
replace filters after 3,000 hours of use.
When indicator light is on, it is time to
change your filters with genuine Medify
replacement filters.
The unit will remind user when
filter needs to be replaced. The
fan will turn off after indicator
light flashes for 1 minute. Unit
will beep to remind user to
replace filters.
7. Reinstall side covers, as outlined
earlier. Side covers will snap back in
automatically.
15
16
8. When filter replacement is
complete, plug in unit and turn on.
Press the ANION button for 3
seconds to reset the unit.
Attention
Turn off and pull out power plug
before replacing the filters. If
replacement filter indicator light
flashes again after replacement,
press the reset button
at the side (as shown)
until indicator light
resets itself.
Helpful Hint
Remove the package of each
filter before inserting into unit.
Label of filter must face upward.