Use Instructions
3/13
FCC REQUIREMENTS
FCC ID: 2AB2MP4TRA
The device complies with part 15 of the FCC Rules.
Operation is subject to the following two
conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that
may cause undesired operation.
Changes or modifications of any kind not expressly
approved by Medicalgorithmics S.A. could void the
user's authority to use ECG.
COMPONENTS & ACCESSORIES
The PocketECG transmitter, model:
PocketECG IV, type: P4TR-AA-ADS (LTE version
for Verizon), P4TR-BA-ADS (LTE version for
AT&T)
A Lithium-ion battery, type: PECGB-III, rated
3,7 VDC, 1700 mAh
An AC plug-in charger type PECGC-III suitable
for charging battery type PECGB-III,
manufactured by Medicalgorithmics S.A., rated
100 VAC – 240 VAC, 0.2 A, 50/60 Hz
MicroSD memory card
PocketECG pouch
Holster (optional, for indoor use only)
Accessories which are needed to the proper
operation but are not included in the PocketECG IV
package:
• SIM card,
• ECG electrodes.
USING POCKETECG IV
1. Safety precautions
• One device is intended to monitor only one
patient at a time.
• It is recommended for the device to work at room
temperature (working temperature is: from 0 ⁰C
to +43 ⁰C (from 32 ⁰F to 109 ⁰F)).
• Air in rooms where the device works should be
free of caustic gasses, steam, and dust. Although
the device is powered from 3.7 VDC and does not
allow for power intake larger than 3 A it is not
guaranteed that it cannot produce a spark which
could initiate the explosion.
• The patient should check with the appropriate
airline carrier to confirm that the PocketECG
transmitter which is similar to a regular mobile
phone may be used on the airplane during
take-off, flight, and landing.
• During handling the device, it is necessary to
avoid excessive stretching and sudden jerking of
cables connecting the PocketECG transmitter
with electrodes placed on the patient’s body. The
ECG cables should not be bent, pulled and
wrapped around the device.
• Parts that wear out and are intended for single
use should be used in accordance with binding
regulations and cannot be re-used. The
electrodes placed on the patient’s body should
be replaced with new ones after no longer than
24 hours if the diagnostic session is to be
continued.
• The manufacturer is not liable for damage caused
by improper use of the device or neglecting
guidelines included in the instructions for use.
• The manufacturer accepts liability only when the
device is used as intended and in accordance with
the instructions for use.
• The ECG cable is permanently attached to the
PocketECG transmitter. In case of damage, do not
repair or replace it, because it may negatively
influence the electromagnetic compatibility of
1
2
3
1
3
2