Use Instructions

10/13
NOTIFICATIONS
NOTIFICATION
DESCRIPTION
ACTION
The device was turned off
for over 12 hours. Would
you like to continue
monitoring?
The PocketECG transmitter
was turned off for over
12 hours.
Make sure, that you have to
stop or continue session, call
a service provider.
ECG Module Error
The ECG module
malfunction.
Turn off and then turn on the
device. If the module still does
not operate correctly, call
a service provider.
Replace Battery
Battery state of charge is
less than or equal to 10 %.
The data are not transmitted
to the remote server.
Replace the battery with the
fully charged.
Insert Battery
The PocketECG transmitter
cannot find the battery.
Insert the battery to the
PocketECG transmitter
Connect Electrodes
Electrodes contact loss. The
ECG signal data are not
transmitted to the remote
server.
Put on the electrodes to your
body.
No Memory Card
The microSD card is not
installed in its compartment
and the session cannot be
initialized.
Install microSD card or replace
damaged one.
No Network
The PocketECG transmitter
cannot connect to the
mobile phone network -
data cannot be transmitted.
Keep the PocketECG
transmitter in the area where
the mobile network is
accessible.
Critically low battery level.
The device will shut down.
Battery state of charge is
2 %, the device will shut
down.
Replace the battery with the
fully charged.
Replace battery before
update
Battery state of charge is
less than or equal to 29 %,
the update will not be
initiated.
Replace the battery with the
fully charged.
Software update in progress
Transmitter software is
being updated.
Do not remove the battery
when the message is visible.
Data synchronization is
required. Make sure that
this device has 3G network
coverage.
Data need to be transmitted
to the remote server.
Ensure that 3G network
coverage is available.